News
NINGBO ECHO FASTENER CO.,LTD
News

Cheapest Square Welded Nut products tells: knowledge about the operation steps of welding nuts

  • Categories:Industry News
  • Author:
  • Origin:
  • Time of issue:2021-09-22
  • Views:0

(Summary description)First, clean the broken ends of the weld nut and the stains on the surface, then use a drill to install a drill that meets the diameter requirements, and start drilling in the center of the section. Please note that the drill bit needs to be fully drilled. After the hole is drilled, the small drill bit needs to be removed and replaced with a larger diameter drill bit. At this time, the drill bit needs to be enlarged, and the drill bit needs to be penetrated.

Cheapest Square Welded Nut products tells: knowledge about the operation steps of welding nuts

(Summary description)First, clean the broken ends of the weld nut and the stains on the surface, then use a drill to install a drill that meets the diameter requirements, and start drilling in the center of the section. Please note that the drill bit needs to be fully drilled. After the hole is drilled, the small drill bit needs to be removed and replaced with a larger diameter drill bit. At this time, the drill bit needs to be enlarged, and the drill bit needs to be penetrated.

  • Categories:Industry News
  • Author:
  • Origin:
  • Time of issue:2021-09-22
  • Views:0

Do you know the operation steps of welding nuts? Follow the editor of Cheapest Square Welded Nut products to have a simple look!
1. First, clean the broken ends of the welded nut and the stains on the surface, then use a drill to install a drill that meets the diameter requirements, and start drilling at the center of the section. Please note that the drill bit needs to be fully drilled. After the hole is drilled, the small drill bit needs to be removed and replaced with a larger diameter drill bit. At this time, the drill bit needs to be enlarged, and the drill bit needs to be penetrated.
2. Then, take a welding rod with a diameter within the specified range, and use a small current to perform surfacing from the inside to the outside of the welding bolt hole.
3. The starting position of surfacing welding needs to be determined according to the full length of the welding bolt. It is usually a normal length. And during the surfacing process, do not burn the outer wall of the bolt.


4. After the surfacing welding is over, you need to hit the section with a hand hammer. In this way, coupled with the heat generated by the arc at the front, the cooling effect at the back and the vibration generated by the knock, the bolts and the threads of the machine body are loosened at this time.
5. Observe carefully. After knocking, if a little rust leaks from the bolt cut position, you can choose the specified nut to set on the surfacing stigma to complete the last step of welding the bolt, and weld the two together.
6. Welding tools and bolts need to be kept clean, otherwise it may directly affect the welding effect of the bolts.
7. According to the bolts of different specifications and sizes, properly replace the welding equipment and auxiliary tools during welding.
In summary, the editor of Cheapest Square Welded Nut products tells: a brief introduction to the relevant knowledge about the operation steps of welded nuts.

language
中国
韩国
韩国
韩国
韩国
韩国
share
share
share
share
share
搜索
确认
取消

Copyright © 2020  Ningbo Echo Fasteners Co., Ltd  All right reserved.  浙ICP备17043072号-1    Powered by www.300.cn